Buy Alumina Filter

06 12月 Buy Alumina Filter

Buy Alumina Filter to clean the molten aluminium from www.adtechamm.com, then you can email sales@adtechamm.com

Buy Alumina Filter and install
Filtration efficiency of Ceramic foam Filter for the aluminum casting plant is closely related to its proper installation and use.
It is impossible to ignore the conventional and necessary measures taken to reduce the occurrence of inclusions in the process operations.
It is necessary to prevent re-contamination of the cleaned aluminum liquid after filtration.

Buy Alumina Filter and install, so you need to pay attention to the following aspects

1. Correct selection of filter plates
The size of the molten aluminium filter plate and the number of holes must be selected in consideration of the flow rate range of the specific casting type, the maximum liquid level of the metal during filtration, the total filtration amount, and the cleanliness of the original aluminum liquid.

2. The pre-melt filtration treatment can not be ignored
such as the normal slag and clearing furnace of the aluminum melting furnace and the holding furnace; the refining in the furnace. In particular, an in-line degassing device is still necessary because it not only reduces the hydrogen content of the melt, but also removes some of the non-metallic inclusions.

3. The filter plate shall be adapted to the square refractory filter box
the two are adapted to seal, so as to prevent the metal from flowing into the casting box from the gap without being filtered, and also avoid floating in the aluminum water due to the excessively light weight of the foam filter plate. And failed.

4. Preheating before use
Preheat to remove moisture and facilitate initial transient filtration. Preheating can be carried out using electrical or gas heating. Under normal circumstances, it takes about 15 minutes.

5. During normal filtration
No slag is required to avoid knocking and vibrating the filter plate. At the same time, the launder should be filled with aluminum water to avoid too much disturbance of the aluminum water.

6. After casting
Drain the metal in the flow cell and filter plate. There is a vibrator abroad that is placed on the filter plate and shaken for one minute to shake off about 75% of the remaining liquid metal from the filter plate.
7. Finally clean the perimeter and remove the filter plate after solidification.

Related posts:

Use Filter Foundry Buy Asian Foundry Filters Use Alumina Ceramic Foam Filter Buy Ceramic Foam Filter China Buy Ceramic Candle Filter Alumina Porous Ceramic Foam Filter Plate Alumina Ceramic Foam Filter Australia Buy Molten Metal Filtration Buy Alumina Ceramic Foam Filter Buy Metal Foam Filter Buy Foundry Filter Buy Ceramic Filter Manufacturers Buy Aluminum Casting Filter Buy Ceramic Filter Foundry